144 Mhz to 28 – 21 MHz Transverter
Board with High Dynamic Range, high frequency stability and extended band.
UR3LMZ transverter with highly stable frequency synthesizer. This allowed us to obtain a long-term stability of 0.2 ppm and to extend the operating range of the transverter 137 – 155 MHz with your HF radio frequency 21 – 32 MHz. This model has 4 LO frequencies that can be easily switched using jumpers on the transverter board – 116 118 120 123 MHz. This allows you to work in an extended range of 140 – 155 MHz or use HF radio with frequencies from 21 MHz. You can easily plug in your CB 26 MHz radio and work on 144. High frequency stability allows you to work in FM, SSB, CW and even digital modes FT8 JT65 and etc.
This transverter board specially developed for severe conditions of reception – contests, DXing, the neighboring powerful broadcasting and amateur stations. The mixer is made on special HI-frequency ADE chip with whopping dynamic range IP3 + 17dBm typ.
This model has SMA RF sockets for minimum losses on VHF.
We are
offering completely built and tested in UR3LMZ lab board that comes with the
English description which contains the circuit diagram of this transverter and
circuit of a simple attenuator board.
This sale
includes the completely built, tuned and tested transverter board with its
schematic diagram and a diagram of a possible connection of this transverter
board to your HF radio.
Technical
specifications
| RF range | 137 … 155 MHz |
| IF range | 21 … 32 MHz |
| IF input power | 1 … 3 mW / 0 … 5 dBm (10mW max) |
| LO frequency | 116 118 120 123 MHz (switchable) |
| LO frequency stability | +/- 0.2 ppm |
| Output power | 10 … 15 W |
| RX gain | typ. 20 dB |
| Noise figure | typ. 1.0 dB |
| Image rejection | typ. 70 dB |
| PTT control | Contact closure to ground |
| Supply voltage | +13.8 V DC (+12 … 14 V DC) |
| Current consumption | typ. 2 A (TX) |
| TX Output transistor | RD15HVF1 |
| RX Input chip | ADE |
| Dynamic range IP3 + 17dBm typ. | |
| Dimensions (mm) | 84 x 68 (3.3 х 2.68 in) |
some soldering works with a cables, wires and connectors. Probably some instruments
would be required. Does not include the interface module, heatsink, power and
RF connectors, wires or cables.
If you were
not satisfied with the transverter board then you ship it back and we refund
your money.







